Won-Door FireGuard With Narrow Lead Post

Horizontal Sliding Fire Door

 

Description

Typical Applications


  • ADA Compliance
  • Area Separation
  • Atrium Separation
  • Corridor Separation
  • Elevator Lobby Separation
  • Fire Barrier - MFW
  • Horizontal Exit
  • Occupancy Separation
  • Pedestrian Walkways & Tunnels
  • Smoke and Draft Control
  • Smoke Compartmentation
  • Stage Proscenium Protective
  • Vertical Exit Enclosure
  • Vertical Open

.
Since 2000 fire & building codes have allowed the use of sliding door systems in a means of egress – with no occupant load limitations – in all occupancy types except Group H.

Because of wide span opening capabilities, the Won-Door FireGuard horizontal sliding fire door allows the unimpeded flow of pedestrian traffic as well as open plan designs. All Won-Door products are manufactured per application and can accommodate most openings, for heights greater than 20'-0" or openings in excess of 700 square feet contact your local sales representative.

Moveable Fire Wall (MFW) is a separate fire-resistive rating for Won-Door FireGuard.  When code restricts the size of penetrations in a fire barrier, the MFW is an alternative that meets the requirements of ASTM E-119 and can be used to protect large openings.

Temperature Rise (TR) labeled fire door is typically used as an opening protective for penetrations in exit stairway enclosures in non-sprinklered buildings. The Won-Door FireGuard TR has been tested and qualifies for this label.

*Increased custom heights available.

FAQs

Troubleshooting

The Won-Door FireGuard fire door assembly may only be installed and serviced by factory-trained personnel. However, it is important that building personnel have a basic understanding of their purpose and operation.

Printed manuals offering more complete information are available in the "more info" tab, from your sales representative or by calling (800) 453-8494. In addition, the following are typical questions that may arise:

How do I operate the Won-Door FireGuard door?

The UL listed Won-Door FireGuard assembly is installed in the open position, typically in a storage pocket, closing upon a signal from either a smoke detector or fire alarm system. The door assembly operates on a 12 volt DC system that includes batteries, a transformer and a microprocessor. A 120-volt AC line connected to a junction box in the storage pocket near the “Control Box” is used to continually float charge the batteries at 13.6 volts. Upon activation of a building alarm, the door will close automatically. The speed at which the door closes can vary, but it is typically set to close at 9 inches per second. Concurrent with the building alarm will be the activation of the horn, an audible signal sounding a steady tone indicating that the system is in “Fire Mode.” It will remain in this condition until the system is physically reset.

How do I reset the door?

Alarm activation is the major reason that resetting the door will be necessary. After the alarm has been cleared, reset the system by operating the rocker switch first to the Close/Clear position to reset the door, then to the Open/Mute position to put the door back into its storage pocket.

How do I get the door to open?

Once the door is in the fully closed position it can be reopened using one of the three following methods.

  • Press the Close/Clear | Open/Mute (CCOM) rocker switch to the Open/Mute position. This will engage the motor and open the partition. The switch is located on one side near the leading edge of the door assembly. Once the door is in operation, it can be stopped at any point by pressing the same switch to the Close/Clear position.
  • Depress the Exit Hardware. Minimal pressure applied anywhere on this plate will cause the door to retract a preset distance from its closed position. If the exit hardware is depressed again after the door has stopped, it will open an additional distance equal to the established opening width. After retracting to the prescribed opening width, if the door is in Fire Mode, it will pause before recycling closed.
  • Operate the door Manually by physically pushing it back to create an opening. This method can be used if there is a complete loss of power.

Why is my door beeping?

If the door is in either the open or the closed position and you hear a fault signal, listen carefully to the horn pattern and compare it to the following charts. This pattern will indicate what has caused the condition. The color of your control box, typically located behind the door, will determine which chart you should use.

For doors with a “Black” control box (018104BTQR)

Alarm Code Description
One Beep DC Fault:VDC: 11.6 - 13.9
Two Beeps AC Fault:VAC: 105 - 130
Three Beeps Switch Malfunction:Key Switch, CCOM, Door Block, Exit Hardware
Four Beeps Drive Train/Hardware Fault:Microprocessor has received a move instruction, but has not received valid data from optical encoder.
Five Beeps Thermal Lock Out/Security Fault:TLS - Fuse 2 or 3 is broken or weakened. Fuse 2 or 3 is broken or weakened. Fuse 2 or 3 is broken or weakened.Security - If door is in Door Lock, If door is in Door Lock, If door is in Door Lock, If door is in Door Lock.
Six Beeps Limit Calibration:The door has executed a limit calibration mode. Close the door to stop the beeping.
Continuous Beep Fire Mode

If you cannot clear the fault, call Won-Door at 800-890-2111 to schedule a factory-trained technician to repair your door.

If your door has a “Beige” control box (C2K)

  • A SINGLE BEEP means that the disconnect switch has been turned off and the door is being serviced. The disconnect switch is located at the top of the control box. The red paddle on the switch can be removed to prevent the switch from being turned back on while the door is being serviced.
  • SIX BEEPS mean that the door needs to be re-zeroed. To re-zero close the door making sure that the leading edge of the door enters the striker before the door stops moving.
  • A CONTINUOUS TONE means that the door is in fire mode and will seek the closed position. As soon as the initiating device has been cleared, operating the rocker or key switch to the closed position will reset the door. It can then be operated back into the pocket.
  • The following trouble codes have specific patterns to aid in identifying problems.
Pattern Trouble Condition Pattern Trouble Condition
1 - 1 - 1 Low DC Voltage 1- 1 - 2 High DC Voltage
1 - 1 - 3 Bad Battery 1- 1 - 4 Missing Battery
1 - 2 - 1 Low AC Voltage 1- 2 - 2 High AC Voltage
1 - 3 Alarm Fuse Failure 1- 3 - 1 Auxiliary Fuse Failure
1 - 4 - 1 Mux Fuse Failure 1- 3 - 2 N/A
2 - 1 Hinderance 2 - 2 Direction Error
2 - 3 Drive Train Error 2 - 4 Obstruction
2 - 5 Curve Obstruction 2 - 6 N/A
3 - 2 Exit Hardware Stuck 3 - 2 - 1 Key Open/Close Both Active
3 - 3 Limit Switch Stuck 3 - 4 Key Switch Stuck
4 - 1 Memory Error 4 - 1 - 1 Firmware Error
4 - 2 ROM Error/ROM Failure 4 - 3 Mux Com Error
5 - 1 Thermal Lockout 5 - 2 Security Failure

Who do I call for service?

To schedule service or request additional information, contact the Won-Door Service Department at (800)-890-2111.

Stack Calculator

For storage pocket depth calculation, please use our Stack Calculator.

More Info

Product Brochures

FireGuard (Sweets)

FireGuard (Sweets)

FireGuard Educational Occupancy

FireGuard Educational Occupancy

FireGuard Healthcare Applications

FireGuard Healthcare Applications

FireGuard Targeted Applications

FireGuard Targeted Applications



.

.

.

Single Page Mailers

mailer_fg_atrium

FireGuard Atrium Separation

FireGuard Wide Span Opening Protective

FireGuard Wide Span Opening Protective

FireGuard ADA Compliance

FireGuard ADA Compliance

FireGuard Assisted Living Facilities

FireGuard Assisted Living Facilities

FireGuard Historic Renovation

FireGuard Historic Renovation

FireGuard Hi-profile Museum Projects

FireGuard Hi-profile Museum Projects

FireGuard Flights of Fancy (Airports)

FireGuard Flights of Fancy (Airports)

FireGuard Building Owner #1

FireGuard Building Owner #1

FireGuard Building Owner #2

FireGuard Building Owner #2

FireGuard Elevator Lobby

FireGuard Elevator Lobby

FireGuard Box Store

FireGuard Box Store

.


.


.


.


.

.

.

.

.

Technical Manuals

Design Manual

Design Manual

FireGuard Owner's Manual

FireGuard Owner's Manual

FireGuard Applications A Code Analysis

FireGuard Applications A Code Analysis

FireGuard Enamel Color Guide

FireGuard Enamel Color Guide

fireguard_horizontal
For more information about our other Won-Door accordion doors click here.

.